 |
|
Prepare
Tools required:
Tri-wing
Small Flathead or exacto razor
Safe Open Tool
Repair Toolkit available HERE
Gather all neccesary tools and place your Zune Flash on a clean flat surface, use a soft cloth or towel to place under it.
|
 |
|
Contents
Same old usual suspects: headphones, inserts, USB cable, and manual.
What a nice looking Gloss black finish.
|
|
|
Step 1
Prior to
disassembly you must remove the top plastic insert in order to access the 2
Tri-Wing screws on the top of the unit.
Now we can
concentrate on removing the anodized aluminum backing. Slide the safe open case
tool in the small gap between the front and back to free the back panel.
If you break the retaining side clips off the
backing, just superglue these back on.
|
 |
|
Step 2
After the backing
comes off we have a partial view of the internals.
Now we can remove the next 3 Tri-Wing screws to
access the memory board underneath.
This dock board houses the components for the
wireless, headphone jack, dock port, etc. |
 |
|
Step 3
After the 3 screws
are out, we can remove the communications board.
Be sure to lift the communications board
up carefully and pop the clip off the flat cable so we can set this board aside. |
 |
|
Step 4
Like the iPod, many
of the internals on the Zune Flash gen2 are held on with mild adhesive. Looks like
Microsoft has been taking notes on Apple!
Simply pry the battery from the plate with your
safe open case tool. The wireless antennae assembly also can be peeled off at
this point.
We now have access to the one remaining
Tri-Wing screw still on the memory board. (short screw)
|
 |
|
Step 4 Cont.
In order to remove
the center frame we need to depress 2 clips on the side of the outer plastic
frame. Once this is complete we can remove the memory board and the LCD screen.
The LCD is held in place with one plastic clip,
simply pop the clip open to remove the screen.
Picture of the
center frame removed. This board sports 2x 8GB flash memory chips.
The Zune 2 LCD screen can easy be removed now,
turn the frame upside down, pop the LCD clip up, then gently tug on the LCD
ribbon to remove.
Note that the battery can be removed with a
steady hand and a solder iron.
|
 |
|
Step 5
Picture of the
Zune gen2 Flash LCD screen. A single driver setup most likely from the same
manufacturer as the original Zune.
If you are having trouble removing the screen,
note that the area where the ribbon is clipped on the board has mild adhesive. |
 |
|
Step 6
Memory board and
battery loose from the center frame. |
 |
|
Step 7
Front panel with
squirkle interface. Microsoft thought it would be a good idea to make this part
non replaceable.
There are 3 plastic pegs which are melted down
which make it difficult to replace, but not impossible.
A poor design from a RapidRepair standpoint! |
 |
|
Step 8 Finished!
The compact new
design of the Zune 2 Flash is a remarkable innovation. We will continue to add
support and repair parts for the Zune Flash gen2 lineup.
Please use this guide for all DIY repairs and
save yourself a headache by doing the job right! |
