Save on iPhones and iPods

Rapid Repair | Products and Services
Rapid Repair | iPod Repair, iPhone Repair, Batteries, LCD Screens and more

Extended life iPod battery for 1G 2G 3G 4G nano Photo Video Mini shuffle

iPod Tool KitiPod scratch remover polish


Certified Secure Shopping


Rapid Repair - Guides | What Can We Help You Fix?

Microsoft Zune Gen 1 30GB Take-Apart-Guide


 

 

Step 1

Tools required:

  • Small Phillips Screw Driver
  • Small Flathead or exacto razor
  • A Safe Open Tool (maybe 2-3)
  • Complete Toolkit available HERE

    Start by removing the bottom dock port spacer with your razor or flathead. Make sure to insert on one of the long ends and not in the middle of the dock. This should pop off fairly easy.

  • Step 2

    After the Dock port spacer is removed you will have access to both screws. Remove these with the Phillips + driver. Now we can crack the shell open.

     

    Step 3

    Insert your safe open case tool in between the small gap. You will have to insert this fairly hard and work it up and won until the bottom of the shell is open. Make sure not to force the case open near the headphone jack or you will tear it off the board.

    Step 4

    Now that we have the backing off of the front panel we can remove the battery and hard drive panels. Remove the 4 screws holding the drive case on the board as well as the clip for the battery. Take the battery out now.

    Step 5

    Remove both clips for the clickwheel and battery now if you haven't done so.

    Step 6

    After you remove the battery and 4 screws for the hard drive case lift up and put the drive with casing above the top part of the Zune (by the headphone jack). Remove the drive cable clip (black part) and then take the sticky tape off the label side of the drive. After the tape is lifted up we can remove the hard drive to replace.

    Step 7

    Now that the drive is out we can remove the rest of the screws to get to the LCD screen and clickwheel. Remove the 6 screws and pull the board out of the front panel.

    Step 8

    We see the board with screen attached free from the front panel.

     

    Step 9

    Remove the 4 clips holding the LCD screen to the board. Now you can gently lift up on the screen to expose the clip holding it to the board. Make sure not to force the screen out until the clip cable has been removed.

     

    Step 10

    We can move to the front panel and replace the clickwheel components now. These should be lifted up easily and taken out of the front panel now. There are no screws holding this in place.

    Step 11

    Front panel is now free from the main unit. We are all done, just go backwards to reassemble. Let us know if anything else should be added to this guide.

    Rapid Repair | iPod Repair, iPhone Repair, Batteries, LCD Screens and more | Fast iPod Repair, iPhone Repair and Zune Repair